Waste Heat Regenerative Dryer Utilizes the high-temperature heat energy from the air compressor exhaust or uncooled high-temperature compressed air for deep desorption regeneration of the adsorbent; it is a new type of compressed air dryer that requires no heating source, has no reheating consumption during heating, reliable operation, low dew point temperature, and energy saving. A new generation of dryer based on the design of an adsorption dryer. Its main features are energy saving and cost reduction. Below, let's understand the characteristics and technical indicators of the waste heat regenerative dryer.

　　The waste heat regenerative dryer is a new type of adsorption dryer, neither belonging to the thermal regeneration type nor the non-thermal regeneration type, but what are the characteristics of the waste heat regenerative air dryer?

　　Product Features of Waste Heat Regenerative Dryer:

　　1. Comprehensive PTA PSA process, no gas consumption during heating regeneration, and small amount of air consumption during air cooling;

　　2. Mature and complete sequence design, fully automatic detection and control are achieved through a PLC programmable controller, with a user-friendly operating interface;

　　3. The valve adopts an eccentric butterfly plate and offset shaft double-eccentric structure to ensure that the butterfly plate does not wear the sealing surface when open;

　　4. High-efficiency gas-water separator designed with a five-stage separation method (vortex centrifugal separation, inertial collision, gravity sedimentation, directional sedimentation, coagulation separation) to ensure effective separation of condensed water;

　　5. High-efficiency cooler and gas-liquid separator to ensure that the adsorbent adsorbs under normal temperature and low humidity conditions, the adsorption load is stable, and the adsorbent life is guaranteed;

　　6. Optimized pipeline and cylinder design, equipment pressure drop 3%;

　　7. The adsorbent adopts high-quality high-strength molecular sieve, and its indicators such as packing density, specific surface area, pore volume, compressive strength, and wear resistance are superior to industry standards;

　　8. Overall skid-mounted design, compact structure, space-saving, and easy installation; users can choose more process designs;

　　9. Product aliases: Waste heat regenerative dryer, adsorption dryer, air dryer, zero gas consumption dryer

　　Technical Indicators of Waste Heat Regenerative Dryer:

　　Working Pressure: 1.3-1.0Mpa

　　Inlet Temperature 100

　　Finished Product Atmospheric Pressure Dew Point -40 Alumina -52 (Molecular Sieve).

　　Control Method: Microcomputer automatic control

　　Cycle Time: 6-8h

　　Regeneration Gas Consumption 2%

　　The waste heat regenerative dryer is a variable temperature adsorption dryer that uses the heat of the high-temperature exhaust gas from the compressor to regenerate the desiccant, allowing for complete regeneration of the adsorbent. Even when used at a low pressure of 0.35Mpa, as long as the compressor load rate is above 70%, the drying device can operate reliably, making full use of its own energy and achieving energy-saving effects. Because the electric heater of the waste heat regenerative dryer is eliminated, and there is no gas consumption during heating regeneration, the waste heat regenerative dryer is a new type of energy-saving compressed air drying equipment.